Instruction Manual

10. Recording Motion Pictures

210

Available in the following modes:

Start recording by pressing the motion

picture button.

A Elapsed recording time

B Available recording time

• Recording of motion pictures appropriate for each mode

is possible.

• The recording state indicator (red) C will flash while

recording motion pictures.

• If approximately 1 minute elapses without an operation

being performed, part of the display will disappear.

Press [DISP] to make the display reappear. This

operation is to prevent screen burn-in and is not a

malfunction.

• When recording a motion picture, do not cover the

microphone with your fingers or other objects.

• Release the motion picture button immediately after you press it.

Stop the recording by pressing the motion picture button again.

• Still picture recording is also possible during the motion picture recording by fully

pressing the shutter button. (P214)

Recording Motion Pictures

About the operation sound that is produced when you stop recording

Since motion picture recording stops only after you press the motion picture button, the

sound of the operation may be noticeable. If the sound bothers you, try the following:

– Cut off the last part of the motion picture using [Video Divide] (P234) in the [Playback]

menu.

The motion picture can not be divided near the very end of it. To avoid this, record

approximately 3 seconds longer.

R1m3737sR1m37s