Instruction Manual

ManualsBrandsLeica ManualsCamerasLeica V-LUX (Typ 114)

4. Recording Modes

Program Mode

Mode:

The camera automatically sets the shutter speed and the aperture value according to the

brightness of the subject.

You can also change various settings in the [Rec] menu.

Set the mode dial to [ ].

Press the shutter button halfway to display

the aperture and shutter speed values on the

screen.

• If the exposure is not adequate when the shutter button

is pressed halfway, the aperture value and shutter speed

turn red and flash.

While the values are displayed (about 10 seconds), you can perform

Program Shift by rotating the rear dial.

• Every time the rear dial is pressed while the values are displayed, it will switch between

Program Shift and Exposure Compensation setting

(P160).

• The Program Shift indication A appears on the screen.

• To cancel Program Shift, turn the camera off or rotate the rear dial until the Program

Shift indication disappears.

Program Shift can easily be canceled by setting a function button to [One Push AE].

(P92)

Displaying/not displaying the shutter speed/aperture indication

> [Custom] > [Expo.Meter] > [ON]/[OFF]

•

When [Expo.Meter] is set to [ON], the shutter speed/aperture

indication B will be displayed when performing Program Shift,

setting the aperture value or the shutter speed.

• Unsuitable areas of the range are displayed in red.

• When the shutter speed/aperture indication is not displayed,

switch the display information for screen by pressing [DISP].

(P63)

• The shutter speed/aperture indication disappears after approximately 4 seconds if no

operation is performed.

6060604.04.04.0

SSSSSS

989898

250 15

4.0 5.6

3060125

2.8

8.0