Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 10 of 119

FCC Compliance

Federal Communications Commission Radio Frequency Interference Statement

FCC Compliance Federal Communications Commission Radio Frequency Interference Statement This

equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference in which case the user will be required to

correct the interference at their own expense. MODIFICATIONS: System modifications or component

changes not expressly approved by Leidos Security Detection & Automation could void the user's

authority to operate the equipment under FCC regulations. SHIELDED CABLES: In order to meet FCC

requirements, only the cabling provided by or approved by Leidos Security Detection & Automation may

be used for system interconnects.

FCC Waiver Conditions

Accordingly, pursuant to the delegated authority in Sections 0.31 and 0.241 of the Commission's rules,

FCC waives the requirements of Sections 15.31(c), 15.35(b) and Section 15.205(a) of FCC rules to permit

the certification and marketing of the Next Gen ProVision device. This waiver is subject to the following

conditions:

 All installations of the ProVision System imaging devices operated under this waiver shall be

restricted to indoor use only.

 Leidos shall inform purchasers that ProVision (PV3) System imaging devices may not be resold

to third parties for use at another installation in the United States unless appropriate arrangements

are made to meet all of the conditions of this waiver.

 This waiver shall apply to the Provision (PV3) System described herein will not have any major

changes made to the transmitter circuitry or to the transmitter housing and position of the antenna

masts within the system that would increase the devices radiated power or bandwidth.

 Leidos shall coordinate operation of its Provision (PV3) System imaging devices with any radio

astronomy facilities within 50 kilometers that receive signals in the 20-40 GHz band, and shall

coordinate any installation which is within line of sight of the observatory at Kitt Peak.