Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 104 of 119

35.0 Procedure

1. Determine whether the power entry panel is to be installed on the top or bottom of the system.

2. Install the power entry panel. System leveling should be completed.

3. Ensure all of the labels are applied to the panel straight and neat.

4. Use a small level, if necessary, to place the labels straight.

5. Place all labels in the order shown in the following figures.

One label might not be in the kit, depending on the system being installed. If the label is not in

this kit, it does not need to be installed. That is label style 6000-22199-00 and has a P/N printed

on the label with a barcode. The P/N and barcode starts with 1600-XXXXX-00. This label is

located at the bottom of the bottom power entry panel and at the top of the top power entry panel.

6. Ensure you plan ahead the spacing of the labels so that they all fit and have even spacing between

them. Usually labels cannot be removed because they can remove the paint.

7. Observe the label keep out areas as shown in the following figures.

Part numbers printed on some the labels can be different than shown depending on the system

being installed.

Note: Care should be taken when placing labels onto the painted panel. If a label is applied

incorrectly and needs to be removed, it might also remove the paint on the panel.

8. Once spacing is determined, start from the power input receptacle and work outward to the top or

bottom. Use of a small level can be used to aid in getting the label straight.

Figure 115: Labeling for Bottom Power Entry