Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 107 of 119

42.0 Installation of Barrier Belt Option

Figure 118: Barrier Belt

The barrier belt has two parts; belt canister and belt receiver. These are installed on either side of the

entrance.

1. Attach the receiver end bracket supplied with the barrier belt (0125-20359-00) to the wall mount

angle bracket (3000-20412-00 or 3000-23604-00) using two M3-0.5x4mm PPH screws (0201-20380-

04). Refer to Figure 119.

Figure 119: Receiver End

2. Attach the wall mount-angle bracket to system entrance left side mounting holes on LCD mounting

bracket (3000-23601-00X) using four each, M8x30mm FSHC screws (0201-22862-30).

3. Loosely install four .58” spacers (3000-22751-00) to entrance right-side LCD mounting bracket using

four each, M8x30mm FSHC screws (0201-22862-30), with ¼” of threads exposed.

4. Place the barrier belt bracket 3000-20411-01 over exposed threads and slide down to lock heads into

bracket keyholes. See Figure 120. Tighten bolts. Earlier version of bracket does not have keyholes.

Assemble as required.

Receiving End

Bracket

Receiving End

Belt End

Wall Mount Angle

Bracket