Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 110 of 119

Figure 124. Monitor Support Post Assembly

7. The install cap is included with pole to open end of monitor pole.

8. With mid-panel installed with grommet cover plate (3000-23666-00) and 1-1/4” ID rubber grommet

(0235-20349-00) installed in upper hole, pull monitor power, video, and USB cables through.

9. Secure the monitor pole bracket (3000-23602-00X) to mounting holes in the LCD mounting bracket

(3000-23601-00X) on the left exit end of the scanner using four M8x30mm FSHC screws

(0201-22862-30).

10. Install pole manufacturer-supplied gasket: remove backing paper to expose adhesive and adhere to

mounting bracket top-side as shown in Figure 124.

11. Attach the monitor pole to the monitor pole bracket using the bolt and washer included with the pole

by the manufacturer. Insert the bolt with washer through the hole in the monitor pole bracket from

underneath and into the monitor pole. Tighten the bolt, but do not over-tighten.

12.

13.

14. Do not use screws included with bracket or monitor damage can occur:

Monitor Pole

Monitor Mounting

Bracket

Monitor Pole

Bracket

Cap

Adhesive-backed

Gasket

Monitor Mount