Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 16 of 119

Figure 2: Belt-Drive Safety Labels

2.4 Toxic Safety Precautions

The consumable materials listed below are toxic to the skin, eyes, and respiratory tract. Good hygiene

practice is recommended; wash your hands thoroughly after leaving your work area. Wear nitrile gloves

and safety glasses when handling the consumable materials:

 Isopropyl alcohol

 Electrostatic discharge (ESD) wipes [490-26003]

Material safety data sheets are available. Consult your local safety and health staff concerning any

questions about toxic hazards.

2.5 Fire Safety Precaution

In the event of a fire, a Halon fire extinguisher or comparable type is recommended to extinguish any fire

inside the ProVision 3 scanner. Any ABC dry chemical fire extinguisher can be used; however, it may

cause additional damage to the equipment.

2.6 Safety Features

The ProVision 3 scanner is specifically designed to prevent injury during operation or maintenance

procedures. Injury can be avoided by using the electrical power switch to remove power from the

scanner, as discussed in the following paragraph.

The power switch, located at either the lower left or upper right of the outer radome with the posing figure

(see following figure), removes all electrical power from the ProVision 3 scanner. In case of an electrical

emergency:

1. Press the portion of the power switch labeled “O” to remove all power from the scanner.

2. Unplug the power cord from the electrical outlet.

Figure 3: Electrical Power Switch (Two Options)