Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 21 of 119

4.2 Scanner Crate Unpacking

The scanner crate lid is secured with approximately ten lag bolts (can differ from system to system).

1. Remove the bolts, lift the lid, and set it aside.

2. Remove all items on the top shelf and set aside. Handle the longest box with care (this box contains

both antenna masts).

Figure 4: Masts and Other Items on Top Shelf

3. Remove the two halves of the top shelf and set aside.

Figure 5: Scanner Crate with Top Shelf to Be Removed

4. Remove one long crate side and the two short crate sides (the ends) by removing the lag bolts. Set the

side and ends aside.

5. Remove 8 lag (2 each column) bolts securing the columns base to the crate base.

6. Remove and set aside all items in the base area, including the four columns. Remove the screws

holding the columns in place as shown in Figure 5.