Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 27 of 119

5.3 Modified Cradle Fork Attachment

1. Take four fork lock pins from the fanny pack provided in the installation kit.

2. Slide a modified cradle fork onto the two fork support tubes, as shown in the following figure.

Figure 13: Fork Support Tubes

3. Insert a fork lock pin into the hole on each fork support tube, then flip the rings over the end of fork

support tubes, as shown in the following figure.

4. Repeat for other side.

5. Repeat steps 1 to 4 for the second Genie Lift.

Figure 14: Modified Cradle Forks with Rings in Place