Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 32 of 119

ring and return the caster to the down position, pull the quick-release pin and lower the caster swing

plate to the dolly position, and then tighten the two upper screws.

5. Repeat for the other caster.

Figure 22: Caster Attachment to Caster End Plate

6. Repeat steps 2 to 4 for the other caster end plate.

7. Retrieve two leverage bars from the installation kit and move to the end of the upper/lower frame

assembly that is further away from the edge of the crate.

8. Insert a leverage bar into the square tube in the center of the caster swing plate; repeat for other caster

assembly.

9. Ensure that each caster is oriented downward, then grasp the end of the leverage bar with one hand

and, with a quick-release pin in the other hand, push down on the leverage bar until the quick-release

pin holes align in the caster swing plate and the caster mount plate.

Both technicians should leverage the two caster swing plates downward at the same time.

WARNING

When leveraging the casters, do not use your feet to step/push down on the rods as this is extremely

dangerous and could also result in damage to the bars and scanner itself.

10. Maintain downward pressure until you have locked the caster swing plate in place with both quick-

release pins, switching hands without releasing leverage on the leverage handle.

11. Ensure both pins are fully inserted into the caster assembly and then slowly release and remove the

leverage bar.

12. Repeat steps 7 to 10 to raise the other end (nearer the edge of the crate).

13. Move each caster pivot lock to the unlocked position.