Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 35 of 119

Figure 24: Grip Point for Rotating Casters

6. Pull the caster pivot lock ring and rotate it to the unlocked position.

7. Grasp the caster with the locking pliers at the grip point shown in the previous figure and turn.

8. Once the caster is turned in towards the upper/lower frame assembly, return the pivot lock ring to the

locked position. Make sure the caster is locked and cannot swivel.

9. Repeat steps 6 to 8 for the other casters.

10. Insert a leverage bar into the square tube in the center of the caster swing plate; repeat for other caster

assembly. Both technicians should leverage the two caster swing plates at the same time.

11. Grasp the end of the leverage bar with one hand and push down on it so the quick-release pins are no

longer bearing weight and can thus be removed.

12. Remove the first quick-release pin and, maintaining downward pressure, switch hands and remove the

other quick-release pin.

13. Slowly reduce the downward pressure on the leverage handle and allow it to rise until the assembly is

resting on the ground.

14. Remove the casters and caster end plates and set aside.