Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 36 of 119

9.0 Upper Assembly Lift

Before beginning this procedure, ensure that the casters and caster end plates are removed.

9.1 Preparation of Assembly and Genie Lifts

1. Remove the two “outer” bolts (nearest either end of the scanner) from each shipping leg, as shown in

the following figure.

Figure 25: Bolts to Remove from Shipping Legs

2. Retrieve the two lifting brackets [1000-11907-00] from the installation kit and attach the first between

the two shipping legs at one end of the upper/lower frame assembly. Insert the hooked tabs on the

lifting bracket into the slots on the side of the two shipping legs nearest this end and lift upward, then

insert the quick-release pin, as shown in the following figure.

CAUTION

Do not attempt to insert lifting bars or lift the upper/lower frame assembly without having quick-

release pins securing the lifting bracket in the locked position. Equipment damage and injury can

result from failing to lock the lifting bracket in the correct position.