Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 44 of 119

9.3 Genie Lift Removal

1. Carefully begin lowering the Genie Lifts. If the shipping legs do not separate from the upper frame,

verify that all bolts have been removed.

2. Rotate the crank handles on the Genie Lifts simultaneously to lower the shipping legs and brackets.

3. When the shipping legs reach the ground, remove the pins holding the cradle forks and lifting bars.

4. Remove the wheel chocks, then roll the Genie Lifts out of the way.

5. Remove the lifting bars and return to the installation kit.

6. Pull the pins and remove the lifting brackets; return them to the installation kit.

7. Remove the cross braces and return them and the shipping legs to the installation kit.

8. Place bolts and quick-release pins into the installation kit hardware case.

9. Break down the Genie Lifts and pack them into the installation kit.