Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 60 of 119

11.17 Outer Window Bracket Supports

1. Install the first of four outer window bracket supports (1000-26549-00) and (1000-26549-01),

ensuring that the middle cover bracket is pointing toward the centers of the window as shown in the

following figure right.

The support is fastened as shown in the following figures left/center with an M6 x 12mm FHC screw

(0201-10069-12) in the top and an M8 x 20mm FHC screw (0201-20452-20) in the bottom. Leave

screws loose.

Figure 65: Outer Window Bracket Support – Top (Left) and Bottom (Center)

2. Install one u-style clip (410-23861) per middle cover bracket as shown in figure above.

3. Repeat for the other three supports.

11.18 Outer Window Bracket Retainers

1. From inside the scanner, install the first of four outer window bracket retainers (3810-10201-00)

vertically on the inside of the first outer window as shown in the following figures.

The retainer can be installed on either the left or right side of the first outer window. The retainer is

fastened with seven M6 x 25mm FBHS screws (0201-20428-30). Leave screws loose. It might be

necessary to push on the window to get the screws started.

Figure 66: Outer Window Bracket Retainer: Overall and Upper and Lower Closeups