Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 65 of 119

2. If the OCP is being located on the left column at the electrical enclosure end, and the power input box

is being located in the upper position at the motor/pulley end of the scanner, you must separate the

cables.

3. Route the power input box/cable to its selected location and route the OCP, Ethernet and any other

cables to the OCP’s selected location.

Figure 69: Cabling Route with Power Input Box, OCP, and Other Cables Together

4. Cable-tie all cables. No cables should be allowed to drape off the side of the scanner, or drape into

the scanner. In addition, the cables should be tied in such a way as to prevent them from becoming

tangled with the moving parts on top of the scanner.

11.23 Top Down Power

Install an optional top down power per 8100-23121-TM option section or 8600-28515-IP.

11.24 Power Input Box

1. Install the power input box at the selected location, either at lower right of the electrical enclosure end

or at upper left of the motor/pulley end.

The power input box is fastened to the outer window bracket support, as shown in the following

figure, with two M6 x 12mm FHC bolt (0201-10069-12) one in each bracket.