Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 67 of 119

Figure 71: Roof Middle Holes

3. Install the roof so that the four middle hole (shown circled in green in the following figure) align with

the brackets that are already installed on the upper frame.

4. The roof is secured using four M6 x 10mm FBHS screws (0201-22775-10) and four M6 fender

washers (0220-23073-00). Leave screws loose until final cover fitting/alignment.

Figure 72: Roof Middle Holes (Viewed from Motor/Pulley End)

11.28 Top Side Covers

1. Locate the first of two top side covers (3000-27085-00), shown in the following figure, and install

two clip-on panel nuts (410-23861) in the locations circled in red in the figure; leave the center hole

blank.

2. Install the nuts with the flat side toward the outer curve, as shown in the following figure.