Installation Manual

ProVision 3 Installation Manual
8100-35521-00
Rev. A1
Leidos Security Detection & Automation, Inc. – Proprietary Page 7 of 119
© 2020 Leidos. All rights reserved
Figure 85: Inner Radome Fastened in Place ................................................................................................78
Figure 86: Inner Radome Slotted Hole and Screw Sticking Out .................................................................78
Figure 87: Ceiling ........................................................................................................................................79
Figure 88: Ramp Support ............................................................................................................................80
Figure 89: Bolt Cover ..................................................................................................................................80
Figure 90: Ramp Assembly .........................................................................................................................81
Figure 91: Floor Center Panel .....................................................................................................................82
Figure 92: Floor Side Panel .........................................................................................................................83
Figure 93: Cover Fitting to Eliminate Gaps ................................................................................................83
Figure 94: Power Input Receptacle .............................................................................................................84
Figure 95: Field Service Tool Connect Page ...............................................................................................87
Figure 96: Field Service Tool Testing, Diagnostics ....................................................................................87
Figure 97: SVDiagnostics............................................................................................................................88
Figure 98: Calibration Window ...................................................................................................................88
Figure 99: Pre-cal and VCO Cal .................................................................................................................89
Figure 100: Pre-cal and VCO Cal ...............................................................................................................90
Figure 101: Using Template to the Locate Foam Block .............................................................................93
Figure 102: End Cap Measurements ...........................................................................................................94
Figure 103: Foam Block ..............................................................................................................................95
Figure 104: Foam Block Placement ............................................................................................................95
Figure 105: Barcode Label Above Block ....................................................................................................96
Figure 106: Top Down View .......................................................................................................................96
Figure 107: Fiberglass Panel Removal ........................................................................................................98
Figure 108: Clean Area with Wipe ..............................................................................................................99
Figure 109: Clean Surface ........................................................................................................................100
Figure 110: Apply Tape Strip ....................................................................................................................100
Figure 111: Peel Paper Off ........................................................................................................................101
Figure 112: Line Up Plate .........................................................................................................................101
Figure 113: Plate Alignment .....................................................................................................................102
Figure 114: End Cap Alignment ...............................................................................................................102
Figure 115: Labeling for Bottom Power Entry ..........................................................................................104
Figure 116: Labeling for Top Power Entry ...............................................................................................105
Figure 117: Label position for Entrance/Exit Panel on Motor End ..........................................................105
Figure 118: Barrier Belt.............................................................................................................................107
Figure 119: Receiver End ..........................................................................................................................107
Figure 120: Belt End .................................................................................................................................108
Figure 121: Monitor Attached With Support Post.....................................................................................108
Figure 122: Monitor Mount Disassembly .................................................................................................109
Figure 123: Install Thumb Screws ............................................................................................................109
Figure 124. Monitor Support Post Assembly ............................................................................................110
Figure 125: Monitor Attached With Fixed Riser.......................................................................................111
Figure 126: Screws and Spacers Installed .................................................................................................112
Figure 127: Riser Installed ........................................................................................................................112