Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 71 of 119

11.31 Middle OCP Cover

1. Grasp the middle OCP cover from the previous section (3000-27080-00) in both hands.

2. Slide the edge nearest the four large mounting holes into the pocket of the entrance/exit cover, as

shown in the following figure left, and check to see if the four holes line up with those on the OCP

mounting bracket. Also check that the screw hole shown circled in red in the following figure right

lines up with the hole on the middle cover brace bracket.

3. Remove the middle OCP cover and adjust the OCP mounting bracket if needed so all holes line up.

4. Tighten the OCP mounting bracket.

5. Install the middle OCP cover by once again sliding its edge into the pocket and lining up the four

mounting holes and one screw hole, ensuring that the cables are tucked behind the middle OCP cover.

6. Fasten the middle OCP cover using one M6 x 16mm FBHS screw (0201-22775-16).

Figure 76: Middle OCP Cover