Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A1

Leidos Security Detection & Automation, Inc. – Proprietary Page 80 of 119

11.47 Entrance/Exit Ramp Supports and Ramp

1. Install the first of two ramp supports [3000-22249-00] at either end of the scanner, as shown in the

following figure.

2. The ramp support is secured with four M10 x 25 FHC screws [0201-20444-25] as shown circled in

green in the following figure.

Figure 88: Ramp Support

3. Repeat steps 1 and 2 for the other ramp support at the opposite end of the scanner.

4. Install the bolt covers 3000-26607-00 and 3000-26607-01 onto the ramps using 3 (0200-28484-08)

SCR, KA35 X 8, TFPH, Z/CLR per cover included with the covers.

Figure 89: Bolt Cover

5. Install the first of two ramps (1000-26611-00) at either end of the scanner, as shown in the following

figure.