Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 86 of 119

12.4 Date/Time Setting

1. Open a remote desktop connection and perform the following or connect a keyboard and mouse

to the ASCU

a. Double-click the SCU icon located on the Desktop of the Field Service Laptop.

b. Follow on screen prompts to connect to the ASCU desktop

c. At the Remote Desktop Connection window, click Yes.

2. Click on the time or date in the lower right corner of the Windows task bar.

3. Click change Date and Time settings.

4. At Date and Time click change Time Zone

5. Select the correct Time Zone from the pull down menu, the time zone should be set to the time

zone of the location where the system is installed.

6. Click OK.

7. Click Change Date and Time…

8. Change the Date and/or the time as needed to match the local date and time.

9. Click OK.

10. Click OK on the Date and Time window.

12.5 Scanner Calibration

Scanner Calibration E4.10.XX and SS5.1.XX

1. Connect the Ethernet cable behind the OCP to a field service laptop and turn the field service laptop

on.

2. Wait at least five minutes.

3. Log in to the field service laptop as sv_admin.

4. Double-click the Field Service Tool icon on the desktop to launch the Field Service Tool program,

which is shown in the following figure.