Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 92 of 119

14.0 Appendix A: ProVision 3 Control Kit Install Procedure

15.0 Purpose

This instruction explains how to install the Provision 3 Vibration Control Kit (1600-21348-00).

16.0 Scope

The Provision 3 Vibration Control Kit (1600-21348-00) is installed on units in the field that are

experiencing mast vibration/excitation due to dynamic, harmonic, periodic, transient or impulse loading

caused by machinery operating, moving, rotating or most likely human movement such as walking,

running or jumping.

This loading is seen in older facilities that have beam spans and floor girder construction that allow free

mode shape.

17.0 Applicable Documents

 ProVision Lock out/Tag out Operating Procedure – 8301-10708-00

 ProVision 2 Installation Manual – 8100-20556-00

18.0 Definitions

 Radome – Curved inner clear plastic panel

 End-cap – Sheet metal panel the holds the radome in place.

19.0 Requirements

Provision 3 Vibration Control Kit (1600-21348-00) includes the following components:

Part Number

Description

Qty

3000-22208-00

FOAM, MAST, ANTI-VIB, BLUE, PV2

5 (4 + 1 extra)

0540-22609-00

TAPE, 3M 4930, 1"W, 1.5YD RL

As required

19.1 Tools and Equipment

Tools required for dismantling Provision 3 to access or remove the inner radome/endcaps.

 Scissors or razor knife

 Tape measure

 Fine tip marker

 Alcohol

 Template to locate foam (3000-22607-00)