Installation Manual

ProVision 3 Installation Manual

8100-35521-00

Rev. A0

Leidos Security Detection & Automation, Inc. – Proprietary Page 94 of 119

21.3 Method 2

1. Clean the area where each foam block is to be attached with alcohol.

2. On each of the end caps measure and mark 3.25 inches up from the bottom of the scanner and

3.75 inches from the tangent of the last bend.

3. Clean an area approximately 4” up and 2” across from the corner of the mark (as shown in the

following figure).

4. Repeat this process for the four endcaps.

Figure 102: End Cap Measurements

5. Prepare the foam blocks by applying tape to the backside of the foam block.

6. Cut 4 pieces of double sided tape 2 inches long.

7. Pull the backing paper of off of the double sided tape.

8. Place one piece of double sided tape on each side of the back of the foam block.

9. Center the tape longitudinally to the foam block face (as shown in the following figure).