Installation Manual

ProVision 3 Installation Manual
8100-35521-00
Rev. A0
Leidos Security Detection & Automation, Inc. – Proprietary Page 98 of 119
© 2020 Leidos. All rights reserved
29.0 Preparing System
To prepare the system:
1. Remove all fiberglass panels necessary to access the notches on the end caps with no OCP mount.
Figure 107: Fiberglass Panel Removal
2. Start at the end cap directly across the exit from the OCP.
3. Clean an area on the inside of the end cap with alcohol at the notch as shown in Figure 108.