User's Manual

RTR-4 Operator’s Manual
5-12 SAIC Proprietary 120300 Rev. D
The Imager handle is used to support the Imager so that its face
is nearly vertical. The X-ray Source is level with the Imager (or
slightly elevated) so that the X-ray Source’s beam is centered on
the Imager’s signal acquisition screen. The object being imaged
may need to be elevated and the X-ray source must be elevated for
the X-ray Source unit’s beam to be properly centered on the screen
Imager Unit with Elevated Source
Alternate X-Ray Sources
Introduction
The RTR-4 can currently be used with the following Golden
Engineering X-Ray sources:
• Inspector 200
• XR150
•XRS3
• XR200
Although the Inspector 200 has been discontinued, it still can be
used with the RTR-4. For more information on setup and
operation of these sources, see the respective Golden Engineering
user’s manual. These manuals are in Adobe PDF format and can
be downloaded from www.goldenengineering.com.
INSPECTOR 200
XR150
XRS3
XR200
(WITHOUT INTERNAL
RECEIVER)