User's Manual

System Operation RTR-4 Operator’s Manual
4-26 SAIC Proprietary 120300 Rev. D
• The RTR-4 imaging software has been properly configured and
is loaded and running.
• An image is displayed in the Original buffer.
• Verify a printer is connected to the printer port, is loaded with
paper, and is powered up.
Procedure RTR0026
Print an image as follows:
Software Description
The RTR-4 imaging software has many unique operating features
differing from the MS Windows® OS installed on the controller
notebooks. RTR-4 operators must be familiar with the Windows®
OS. This manual does not cover Windows® operation.
Information and training on Windows® may be located at
http://www.microsoft.com. RTR-4 application-specific features
and commands are listed and described in the following
paragraphs.
RTR-4 Functions
In most cases the RTR-4 commands can be accessed by:
• The pull-down menus listed in the Main Menu bar at the top
of the screen.
• A button on the toolbar displayed under the Main Menu bar.
• The Function Keys (F1-F12) located at the top row of the
keyboard.
• Various keys or key combinations (refer to the Key Map
selection under the Help pull-down menu for more
information).
• The RTR-4 application may be operated using the keyboard in
the advent of a mouse or pointing device failure.
Once the RTR-4 is set up and configured, the operator shall
launch the imaging software and verify that it is running
normally and properly configured.
STEP ACTION
1 Select Print from the File pull-down menu to print
the image in the active buffer.
2 Select Print Window from the File pull-down menu
to print the entire Main Menu screen.