Use and Care Manual

Take assembled SEAT PANEL (6) and one of the arm frames, keep the arm frame
standing and attached the SEAT PANEL (6) to the inside of the arm frame, secure
with the indicated nuts and bolts.
Insert the other arm frame
on the other side and
secure loosely with
nuts and bolts.
Take the Lower Support
Beam (5) and secure
under the seat between
the arm frame with
nuts and bolts.
Once the bottom half is finished,
take the BACK PANEL (7) and
place it gently on part 4 of the
arm frame.
Secure with indicated hardware
in the diagram.
Tighten all nuts, bolts,
and screws once
every part and
assembled pieces
are in place.
Congratulations
on your assembly!
PARTS AND HARDWARE LIST
1 2
6
3
7
4
5
A B
Mallet
Socket & Wrench
Phillips
Screwdriver
Tools required for assembly
13mm
ARM REST
LOWER SUPPORT BEAM
NUT & BOLT
SCREW
FRONT LEG
SEAT
DIAGONAL SUPPORT
BACK
VERTICAL SUPPORT
AR55 FL90 DS80 VS92
LSB59
N08-11 S04-4
STS BKS
X 2PCS X 2PCS X 2PCS X 2PCS
X 2PCS
X 16PCS
X 6PCS
X 1PC
X 1PC
STEP 1: STEP 2:
STEP 3: STEP 4:
Assembling the Rocker Arm Frame Assembling the Bottom Half
Assembling the Upper Half Finish
Take one piece of the following parts with a letter “R” behind
each number: 1 , 2 , 3 , 4 , 8 (”R” = Right)
1: Part 1 to part 4
2: Part 3 to part 2
3: Part 2 to part 1
4: Part 4 to part 3
Use indicated hardware, directed
by diagram.
REPEAT steps 1 through 4 above using parts
labeled with a letter “L” (”L” = Left) after the part number.
B
A
A
4R
3R
1R
2R
A
7
6
5F
A
A
A
5B
B
Left
Right
A
BAR ARM CHAIR
ITEM # TX 93730, TX 93732, TX 93733, TX 51027, TX 95141
1. Do not tighten bolts until fully assembled.
2. Recessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
IMPORTANT: READ CAREFULLY BEFORE BEGINNING
Recessed Hole
Pre-Checked
Tools included