Instructions / Assembly

PORCH SWING
ITEM # TX 94072, TX 94074, TX 94090
1. Do not tighten bolts until fully assembled.
2. Recessed holes to face outward.
3. Insert bolts with washer and secure with washer and nut.
4. Pre-checked side must always face downward or inward.
IMPORTANT: READ CAREFULLY BEFORE BEGINNING
Recessed Hole
Pre-Checked
PARTS AND HARDWARE LIST
1/4” FLAT WASHERS(6)
TOOLS NEEDED
Hammer and 7/16" wrench,or adjustable
wrench,pliers, and a standard csrewdriver.
ARM SUPPORT(2)
ARM(2)
BACK
EYE BOLT(2)
CHAIN(2)
CEILING HOOKS(2)
HEX NUT(6)
*Standard hardware items
may be purchased locally.
QUICK LINK(2)
SEAT
1/4” x 2-1/4” SCREWS(2)
1/4” x 2-3/4” CARRIAGE BOLTS(6)
Position and insert 2-1/4" screws in 2 holes in back. Place screws
through 2 holes in seat using 1/4" washer and 1/4" nut.
NOTE: Do not mount back assembly incorrectly.
STEP 1: STEP 2:
Attach each arm to back by placing 2-3/4" carriage bolt through chain,
then through hole in tapered end of the arm(straight edge of the arm facing in),
then attach to back with 1/4" washers and 1/4" nut.
Before using this chain, nspect each link in
the chain to make sure all are tightly wound
and secure. Failure of the chain could cause
serious injury.
Should any defect be found, contact Customer
Service for free replacement.
WARNING:
1/4” NUT
& WASHER
2-3/4’
CARRIAGE
BOLT
1/4” NUT
& WASHER
2-1/4”
SCREW
1/4” NUT
& WASHER
2-1/4”
SCREW
1/4” NUT
& WASHER
2-1/4” SCREW
1/4” NUT
& WASHER
2-1/4” SCREW
CORRECT
INCORRECT