Instructions / Assembly

You package contains two eye bolts. These should be screwed into a solid
material(ceiling joists) as shown in Figure A.The screws should be
spaced 46 inches apart for the H-24 and 58 inches apart for the-25.
Drill a 1/4 inch pilot hole for each eye bolt. Lubricatethe threads with wax,
oil,or soap for easiest installation.
Be sure to screw the eye bolt completely into the
ceiling joists so that no threads are visible.
NOTE: If the desired location of the wsing does not match the
overhead joist location, a suitable 2x4 header should be attached
to the joists. The hooks may then be screwed into the header as
shown in Figure B.
WARNING: Periodically check the swing chain,eye bolts,
and all the hardware for signs of signs of wear and possible metal
fatigue that hardware for signs of wear and possible metal
fatigue that could allow the swing to fall and cause serious
injury. Check all hardware to be sure bolts and nuts are tight.
Call our Customer Service Departments for replacement parts.
© 2014 UGS Co., Inc. All Rights Reserved
DISTRIBUTED BY:
UNITED GENERAL SUPPLY CO., INC.
HOUSTON, TX 77036
www.LeighCountry.com
Limited Warranty and Care Instructions
LIMITED ONE YEAR WARRANTY (NON-TRANSFERABLE)
Proof of purchase (dated register receipt) will be required for warranty claims.
PROPER CARE INSTRUCTIONS
Customer Service may be reached Monday through Friday from 9:00a.m. to 5:00p.m. CST.
[e-mail] OR 1-877-87LEIGH (53444)
This product is covered under United General Supply’s (UGS) one (1) year limited warranty. To the original purchaser of this piece of furniture,
cooler or accessory; UGS warrants that it will be free from defects in material and workmanship for up to one year from the date of purchase
under normal use and proper care.
Replacement of defective or missing parts will be sent at no charge to the customer for a period of 30 days from the date of purchase. UGS will no
longer be responsible for missing parts or hardware 30 days after date of purchase. Freight, packaging, labor or material charges to and from our
customer service center is not covered under the warranty and is therefore the customer’s responsibility.
The limited warranty does not cover this piece of furniture, cooler or accessory for commercial purposes, abusive use, damage by modification,
freeze damage, rust, fading and issues caused by improper care.
For minor defects or missing parts/hardware, please contact customer service immediately upon purchase. Please do not return product to the
store unless you are completely unsatisfied with the product, or if the damage is irreparable. A customer service agent may help determine
whether the damage is reparable and will provide further instructions. For returns and refunds, please refer to your local store with proof of
purchase for such cases.
If left untreated, wood will naturally weather. During long periods of non-use, store furniture or cooler in covered and dry place. For the least
maintenance, place your furniture, cooler, or accessory under a covered area.
To preserve and maintain the original finish of Char-log/ Aspen log furniture, we recommend that a light lacquer coating be applied every 4 to 6
months depending on the seasons.
We recommended an exterior poly-urethane product that features a clear satin or semi-gloss finish and a fast drying process.
FIGURE A FIGURE B
CORRECT INCORRECT
JOISTS
HEADER
POSITION OF
BEARING PORTION
OF CEILING HOOK
NOTE:
After hanging your swing,
it is recommended that the open
ends of the ceiling hooks be
closed using a pair of pliers.
STEP 3: STEP 4:
Place arm supports between each arm and seat at the front of the awing.
Hook link of chain on each side on 12” eye bolts and slide eye bolts
throungh arms, supports, and seat as shown. Using nuts and washers,
tighten eye bolts until they indent the surface. This will prevent the
chain from coming loose from the eye.
12” EYE BOLT
CHAIN
LONG
LENGTH
SHORT
LENGTHS
1/4” NUT
& WASHER
NOTE: Make sure that the two short, equal lengths
of chain connect to swing arm while the longer of
chain attaches the swing to the ceiling or swing
frame.
NOTE: To avoid a possible hazard, please
cut off eye bolts flush with the bottom of
the nuts after assembly is complete.