REFRIGRATOR MANUAL DERFOST RQ-50H
1.
2.Correctly positioning Well Ventilating There is need of good ventilation around the refrigerator for easy dissipation of heat, high efficiency of refrigeration and low power consumption. For this purpose, sufficient clear space should be need around the refrigerator. Its back is at least 100mm away from the wall, its sides at least have a space of 100mm separately and the height from over its top is not less than 200mm.
2.Correctly Positioning Protection from Heat The refrigerator should be far away from any heat source or direct sunshine. Fixing Stable Floor on which refrigerator will be placed must be flat and solid. It should not be laid on any soft material such as foam plastic, etc. If the refrigerator is not on the same level, adjust the screws suitably. The refrigerator should not be placed near anything which may echo.
3.Cautions It must be checked that the voltage used should be the same as the rated voltage before the refrigerator is used. Water contained in food or getting into air inside the refrigerator by opening doors may form a layer of frost inside, It will weaken the refrigerator when the frost is thick, Therefore you should defrost manually when the ice is thick. When defrosting, a pan is needed to put under the evaporator for taking the defrost water.
4.Changing the reversible door This refrigerator has the capability of either opening the door from the left or right side. The unit is delivered to you with the door opening from the left side. Should you desire to reverse the opening direction, please follow these instructions. NOTE: Before Reversing the door ,the power must be shut off. All parts removed must be saved to do the reinstallation of the door. This refrigerator has been built with the door hinges on the right.
5.Maintenance The refrigerator should be cleaned and maintained once a month. When performing maintenance, make absolutely sure that the power plug is first disconnected from the power outlet. Wipe the inner and outer surface of the refrigerator and its accessories with wet cloth. If they are too dirty, scrub them with neutral detergent, and then clean them with water and dry them with clean cloth.
6. Troubleshooting 1. When the refrigerator does not work Check if there is a power failure. Check if the power plug is plugged into the power outlet. Check that the fuse has not blown. 2. When the refrigerator is cooling excessively The temperature control dial may be set too high. If you place foodstuffs containing a lot of moisture directly under the cool air outlets, they will freeze easily. This does not indicate a malfunction. 3.
7.Technical specifications *For the detailed technical specifications, please refer to the nameplate at the back of the refrigerator. *Specifications are subject to change without prior notice.
11
10
