Users Manual
If no RDS information is available, the currently tuned frequency is shown.
7.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only
at stations with good signal strength, select Menu > Scan setting > Strong stations only?
> Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select
Menu >Audio setting > FM weak reception: Listen in mono only > Yes.
8 AUX mode
Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode,
1).Connect the external audio source to the Aux In (RCA) stereo socket.
2). Either press Mode until the display shows AUX in or select Menu> Main menu >
AUX in.
3). Adjust the volume of MSY5 (and, if necessary, the audio source device) as required.
9. Bluetooth mode
Prior to pairing, verify your device supports Bluetooth 4.0+EDR A2DP and your device
is not connected to any other Bluetooth product. Devices may pair differently. Below is a
general guide.
1. Press to source to Bluetooth mode. This will power on the Bluetooth. Turn the volume
up about ΒΌ to start. Also turn up the volume on the source device (the device you are
streaming from).