Datasheet

114 www.lemo.com
®®
ø C
ø A
L
S 2
Part number
FFM.2C.130.LC
Note: for bend reliefs to be used with this nut see section «Accessories»
page 141.
● Material: Chrome-plated brass (0.3 µm)
Nut for bend reliefFFM
Dimensions (mm)
AC LS2
14 8 12.2 12
Note: other accessories are also available. See section «Accessories» on page 135.
Blanking caps for fixed sockets
Note: this caps are suitable for use with any alignment key configuration.
The last letter «S» of the part number stands for the material of the O
ring (silicone rubber). O-ring’s made from FPM are also available; if requir-
ed, replace the letter «S» by «V».
● Body material: Nickel-plated brass (Ni 3 µm)
● Lanyard material: Stainless steel
● O-ring material: Silicone rubber or FPM
BRF
ø A
M
sliding loop
B
L
N
Part number
BRF.2G.200.NAS
Dimensions (mm)
AB LMN
18 12 14.0 6.0 85
● Maximum operating temperature: 200°C
● Watertightness: IP61 according to IEC 60529
Blanking caps for fixed and free sockets
Part number
BRE.2G.200.NAS
Note: these caps are suitable for use with any alignment key configuration.
The last letter «S» of the part number stands for the material of the O
ring (silicone rubber). O-ring’s made from FPM are also available; if requir-
ed, replace the letter «S» by «V».
● Body material: Nickel-plated brass (Ni 3 µm)
● Lanyard material: Stainless steel
● O-ring material: Silicone rubber or FPM
● Maximum operating temperature: 200°C
● Watertightness: IP61 according to IEC 60529
BRE
ø A
M
N
B
ø 3.5
L
Dimensions (mm)
AB LMN
18 12 10.6 6.0 85
Accessories (2G series)