User's Manual
IR LEARNING PROCEDURE
STEP** D 3020 SOURCE INDICATOR BLINKS TV REMOTE CONTROL FUNCTION KEY TO PRESS
FUNCTION LEARNED BY D 3020 FROM TV
REMOTE CONTROL
1 OPT Volume + Volume increases
2 COAX Volume - Volume decreases
3 AUX Mute Mute on/o
4 PHONO Power ON Switch to operating mode
* Dependent upon the D 3020 going rst to standby mode after 30 minutes of inactivity.
** All four steps must be followed exactly to complete the IR Learning process.
DELETE IR LEARNED COMMANDS
Press and hold “ MUTE” on AMP3 remote control until “OPT” continuously blinks. Press and hold “ MUTE” again until “OPT” stops blinking. All IR learned
commands are now deleted.
OTHER FEATURES
TV CONNECT
TV Connect is a new software enabled feature that allows the D 3020
to provide the sound for your TV. TV Connect enables D 3020 to learn
the mute and volume control commands from any TV remote control.
Additionally, the D 3020 will automatically power up to OPTICAL source
upon detection of digital TV output signal at OPTICAL input.*
With TV Connect fully integrated, you can use your TV remote control to
manage the following features of D 3020:
1 Adjust Volume up/down
2 Enable or disable MUTE function
3 Switch ON D 3020
HOW TO CONFIGURE YOUR D 3020 WITH TV CONNECT
TV Connect setup requires the digital optical output of your TV to be
connected to the OPTICAL input of your D 3020. With this setup and with
proper conguration, when you turn ON your TV, the D 3020 powers up from
standby mode and the TV input (OPTICAL) is automatically selected.* The
D 3020 can also be awakened by pressing the top panel’s o and the power
ON button of either AMP3 remote control or TV’s remote control.
The following congurations are necessary to integrate TV Connect with
your D 3020.
• Enable auto standby mode.
• Enable auto sense mode.
• Perform IR (infrared) learning with TV remote control.
ENABLE AUTO STANDBY MODE
• While at standby mode, press and hold “OFF” button of the AMP3
remote control for a few seconds until all indicators on the front screen
wake up and blink once.
ENABLE AUTO SENSE MODE
• While at standby mode, press and hold SOURCE d button of the AMP3
remote control until o and S icons at the top screen wake up and blink
once.
PERFORM IR LEARNING WITH TV REMOTE CONTROL
a With D 3020 at operating mode, press and hold “ MUTE” of AMP3
remote control until “OPT” continuously blinks.
b Single press “Volume+” of TV remote control.
c After a one second gap, single press again “Volume +” of TV remote.
• “OPT” quickly blinks twice and then moves on to “COAX” as it starts
blinking to prepare learning “Volume - “.
• Perform the same operation to learn “Volume-“, “Mute” and ”Power
ON” respectively as per IR LEARNING PROCEDURE below.
d When the D 3020 successfully learns all four keys of TV remote control,
it will automatically exit the learning mode and return to normal
operation.
TURN OFF TV’S INTERNAL SPEAKERS IF SO EQUIPPED
It is recommended that you disable the TV’s internal speakers so that only the
D 3020 is heard. This setting is usually accessible from the TV’s Setup Menu.
Consult your TV’s Instruction Manual for instructions specic to your make
and model of TV.
8
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ