Operation Manual

5
INITIAL STARTING-UP
MAINS CONNECTION
Ensure that the mains voltage of your home corresponds to the operating
voltage of the unit. Your unit is ready to be connected to a mains voltage of
110V/60Hz or 220V/50Hz.
AMPLIFIER CONNECTION
Connect audio plugs to Alert input on your mixer or amplifier:
 Red plug into R/H channel input.
 White plug into L/H channel input.
Note: This turntable has a built-in amplifier to avoid damage on the
turntable or your audio-system. Do not connect this turntable to your audio-
system by using the phone-input because this input is amplified also.
Playing a record
- Remove the Dust cover from the turntable.
- Place the record of your choice on the turntable. If it is a 45 rpm, do
not forget to place the adaptor on the record spindle.
- Choose the desired playing speed:
 33 rpm -> button unlocked
 45 rpm-> button locked.
- Release the Tone-arm lock.
- Push in the arm lift button (tone-arm will go up)
- Place the cartridge vertically over the first track of the record the
turntable starts turning
- Push out the arm lift button (tone-arm will lower record starts playing)
- When the record is over, the tone-arm returns to its rest and the
turntable starts turning.
Remark: While the record is ON, If you wish to:
Stop the record while its playing
− Press the stop button; the cartridge comes up and returns to it’s
rest; the turntable stops turning.
− Replace the protective cap on the stylus
Close the tone-arm lock.