Operation Manual

Pairing and Connecting the headset with a phone
1. Press and hold the power switch button about 7-9 seconds until you see the blue and red indicator light
flashes rapidly and continually by turns,then release the button.
2. Activate the Bluetooth feature on your phone and search for the headset.
3. Select the headset (Lenco BH-100 ) from the list of devices found by your phone.
4. When pairing successfully,the indicator light will stop flashing,the blue indicator light flashes once
every 3 seconds in standby mode.
Reconnecting the headset with a phone
1.Your headset will attempt to reconnect automatically each time you turn it on,but this feature may be
unavailable on some devices,you can try to reconnect from paired devices on phone.
Answering a call
1.Short press the power switch button to answer a call when you hear incoming call tones.
2.When you are listening to music,the music stops during a call.
Ending a call
1.Short press the power switch button to end a call.
Rejecting a call
1.Press the power switch button for 2 seconds to reject a call when a call comes in.
Redialing the latest call
1.Short press the power switch button for 2 times continually, and then it will make a call to the latest
number you dialed.
Volume Control
1.Long press the volume up or down button to adjust the volume.
2.You will hear a beep when volume level of the headset reaches its’ highest level.
Play or Pause music
1.Press the power switch button to select play/pause the song
Previous or Next song
1.Short press and then release the previous/next song button to select previous/next song.
2.While playing the song, 'Short press and release' the previous song button only go to the beginning of the
current song, then 'Short press and release' button again to go to the previous song.