Operation Manual

C. To recharge the built-in rechargeable battery:
You can charge the Bluetooth Speaker’s battery in two ways:
• Connect Bluetooth Speaker to the Computer. Or,
• Use the USB power charger. (not included)
D. Connection and Charging:
• Connect the Bluetooth Speaker’s Micro USB connector with the Computer’s USB port
through USB cable (supplied).
• The charging LED turns ON in red light. (make sure that the computer is turned ON)
• The charging LED will switch to green light when it’s fully changed.
• Disconnect the USB cable when it is done.
Charging LED Function
1. No DC power input: LED light OFF
2. In Charging: Light On in red color
3. Charge Completed: Light color from red switch to green
E. Turn ON/OFF & Play from Bluetooth device:
• Slide the power switch to “ON” position to turn on the Bluetooth speaker.
• The mode LED indicator (Bluetooth / Aux In) will turn ON and light blue with blink every
half second once, when it is searching Bluetooth devices.
Power & Mode Indicator Function:
Item Description Light and Mode Function Mode Light Status
1. Power in OFF Light OFF.
2. Power in ON Light ON;
2.a At Bluetooth searching mode: Blue light blinking; every half second
once.
2.b At Bluetooth Paired mode: Blue light blinking; once per 3 seconds.
2.c At AUX In Mode:
(3.5 mm jack plugged In)
Light color switch to red color from blue.
• Then, activate the Bluetooth function in your Bluetooth device (such as Mobile Phone
or Personal Computer); the device will enter to Bluetooth searching mode
automatically, if not, tap the relate selection to manually enter to searching mode. (refer
to your device’s manual when necessary)
• Your Bluetooth device should show “Lenco BTS-110” in list, and then select it for
pairing. Waiting for some seconds and you will see connected message as shown on
your Bluetooth device.
• For some Bluetooth devices, you may need to input “0000” as pairing password. Once
devices paired, the Bluetooth Speaker will beep twice and the mode LED stays steadily