Instructions

7
Connect the power adapter (included) to the DC IN socket at the rear of the
device and the mains socket.
Get the network environment ready
• For wireless WiFi
Make sure you have setup the wireless network and you have the WEP,
WPA or WPA2 security password to activate the connection.
You may also use the WPS (WiFi Protected Setup) function for an easy
pairing between the network device and the device. Check if the light
indicators on the network device are in an operational state.
Connect the device to power supply.
The first time you turn the device on, it will go straight into the Wizard Setup
menu. Select YES
YES
YES
YES to continue the setup. For the details of the Wizard Setup,
you may refer to Section 5.2.1. If NO is selected, you will be asked if you
would like to run the wizard next time.
Once you have successfully set up the network, the device will automatically
connected to the network next time when you turn the device on again. In
case you desire to change the network, enter System
System
System
System Setting
Setting
Setting
Setting to configure the
corresponding connection. You may refer to Section 5.2.1 and 5.2.3 for
details.
Press and hold /MODE
/MODE
/MODE
/MODE on the device or press on the remote
control to enter operation mode , press again to enter standby mode. Time,
date and any active alarm times will be displayed on the screen.