User Manual

Turntable Quick-Start:

1. Changing Platter Speed

Press the 33/45 ROTATION SPEED SETTING buttons to change the platter rotation speed.

When you press 33 and 45 buttons together, the platter will rotate at 78RPM. This is for old

records. To play those 78RPM records you need to change the cartridge and stylus! Your

turntable is equipped with an Audio-technica AT-3600E which can not support 78RPM records.

Please refer to the Audio-Technica website to select the compatible cartridge.

2. Starting and Stopping the Platter

Use the PLAY/PAUSE BUTTON to switch back and forth between platter rotations and pause

modes.

3. Pitch Control

1) The pitch adjustment is a fine adjustment to the platter's RPMs.

2) The pitch adjustment is variable and may be adjusted between -10% and +10% of the

platter-selected speed.

3) The pitch is changed by sliding the Pitch Slider in an up and down motion.

4) The indicator dots on the rim of the TURNTABLE PLATTER can be used to visual approximate

the platter pitch. These indicators are lit by the STROBOSCOPIC LIGHT as they pass by the

POWER SWITCH. At different pitch levels each row of STROBE INDICATORS may appear stand

still.

Note: The use of heavy fluorescent lighting directly above the turntable will defeat the

STROBE LAMP PILOT LAMP affect indicator accuracy.

Set-up

Turntable Installation:

1. Do not place the unit in a location where it will be exposed to direct sunlight or near any type

of heating appliance.

2. Do not place the unit in a location where there is high humidity or a lot of dust.

3. Cartridge may pick up slight sound pressure or vibrations of nearby speakers. For best results,

do not install this unit too close to speakers.

4. Install this unit on a horizontal surface that is stable and vibration free.

5. The rubber feet have been specially designed to isolate the unit from excess vibration. The feet

may also be used to stabilize the main body horizontally. Adjust the height of the unit by turning

the feet in a clockwise or counter-clockwise direction.

Tonearm Balance and Stylus Pressure:

1. Adjustment of horizontal zero balance and stylus pressure:

2. Remove the stylus protective cover, if so equipped. Never touch the stylus tip during the

adjustment.

3. Lower the TONEARM LEVER.

4. Release the tonearm clamp and release the tonearm from the arm rest.