MES-204 User Manual Twin Display Car DVD Player Please read the instruction carefully before operating the unit. For information and support, www.lenco.
LOCATION OF CONTROLS Main Unit 1. LCD (TFT) Display 2. Power ON indicator : When the unit is switched ON, the light will illuminate. The light will change from GREEN to RED if unit is switched to Standby mode. 3. Charging indicator: The charging indicator will go off when the battery becomes fully charged. 4. Remote sensor 5. LCD MODE / DVD/ USB/SD button: To access LCD mode and source mode. Short press to enter LCD mode. Press , on main unit to select the aspect ratio between 16:9 and 4:3.
6. SETUP button : To enter the Setup menu 7. button :Press once to pre-stop (resume with ), press again to stop playback. 8. button : To start and pause the playback 9. : To directly access the previous or next chapter (DVD) or track (CD). , , , buttons: To navigate through the on-screen menus. 10. Enter button: To confirm the selection during menu navigation. 11. DC IN 9V jack 12. Power ON/OFF switch 13. Headphone jack 14. COAXIAL jack 15. AUDIO jack 16. VIDEO jack 17.
buttons : Use these buttons to adjust the Brightness, Contrast and Color level of the monitor. 8. Power ON/OFF switch: To switch on the monitor 9. DC IN 9V jack 10. VIDEO jack 11. AUDIO jack 12. Headphone jack 13. VOLUME control : To adjust the volume 14. Stand : Lift up the stand from its groove; Support it against the stand or draw the stand out and then fix it in position by clicking down the LOCK button. 7. Remote control 1. LCD Mode : To access LCD mode of the unit. 2.
Note: “ ” will be displayed if the function you select is not available. Installing Battery Insert 2 “AAA/ UM4” batteries to the remote control prior to use. Make sure to match their polarities (+/-) to the markings inside the compartment. NOTES: - Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. - In order to avoid leakage, always remove the batteries when unit will not be used for a long period of time.
Using the main unit and monitor together Using the main unit only EN - 5
Cautions: *The AC adaptor included with this unit is for its use only. Do not use it with other equipment. *Turn off the unit before unplugging the AC adaptor from the unit so as to avoid the unit being damaged. *When the unit is not going to be used for long time, disconnect the AC adaptor from the AC outlet. * Be sure to use it near the wall outlet and easily accessible. If a malfunction occurs, disconnect the plug from the wall outlet at once. *AC adaptor is used as the disconnect device.
Cautions • Use only the included 12V car power adaptor. Use of any other 12V car power adaptor could damage the unit. • The 12V car power adaptor included is for use with this unit only. Do not use it with any other equipment. • In the interest of traffic safety, drivers should not operate the unit or view videos while driving. • Make sure the unit is fastened correctly to prevent from falling in the vehicle in the event of an accident.
CONNECTIONS Disconnect all devices from the mains supply before connecting. Connecting to the Amplifier Connecting to TV Slide the AV switch to “IN” position to input the AV signal. Slide the AV switch to “OUT” position to output the AV signal.
USING HEADPHONES / EARPHONRS Maximum output voltage 150mV HEADPHONE VOLUME WARNING Connect earphones with the volume set low and increase it if required. Prolonged listening through some earphones at high volume settings can result in hearing damage. When headphones/earphones are connected, no sound will be emitted from the unit’s speaker. Caution: Avoid listening to sound at levels which may be harmful to your ears. Continuous use of earphones at high volume can damage the user’s hearing.
Variable slow motion (DVD & VCD) 1. While the disc is playing, press Slow button. 2. Press the Slow button repeatedly to change slow speed. 3. Press to resume normal playback. Changing chapter/track While the disc is playing, press or to go immediately to the next or previous chapter(DVD), or to the next or previous track(CD, VCD). Zoom (DVD, VCD) While a disc is playing, press Zoom until you reach the zoom size you want. The button cycles through x2,x4,x1.
Search a desired section 1. Press Search button to enter the search mode. 2. Use number buttons to input the chapter number (DVD ) or playback time (DVD,CD). Then press Enter button to jump to the target location immediately. Note: Press Clear button to cancel the incorrect input.
3. Press buttons to select the title and press Enter button to confirm. 4. Press buttons to select the chapter and press Enter button to confirm. Note: For CD, press buttons to select desired track and press Enter to confirm. 5. Repeat step 3-4 until you have finished programming your selections or when you have programmed the maximum 20 tracks. 6. Press Clear or button to delete. 7. Press button to start playback. Press Program to cancel.
PLAYING MP3/DIVX/PICTURE FILES DivX®, DivXTM Certified, and associated logos are trademarks of DivX, Inc. and used under license. This unit can play MP3, DivX and Picture files recorded on CD-R/CD-RW discs, USB flash drive and SD/MMC card. 1. Insert a disc. 2.It will take a short while for the system’s reading data and then playback starts automatically. 3. MP3 files: Use buttons to select a file in the menu and press Enter or to start playback.
*Sort file With this function, you can set the file sorting method and sequence. 1. In stop mode (For picture files, press Menu button to enter main menu), use , button to select “ Sort File” and press Enter to confirm. Following window will appear: 2. Use and Enter button to select the file sorting method ( “By type”, “By name” or “ By date” ) and display sequence ( “ascending” or “descending “). Picture (Jpeg) playback: Thumbnail mode 1. During Jpeg playback, press button once to enter Thumbnail mode.
Rotate mode In rotate mode, press to select a picture and press to rotate the picture 90 degree clockwise. Select “Reset” and press Enter to reset the picture to original direction. Select “Return” and press Enter to return to Thumbnail mode. Zoom function: * During Picture(Jpeg) playback, press Zoom until you reach the zoom size you want. The button cycles through 200% 25% 50% 100%. 150% * When the magnification level is greater than Normal 100%, use the / to pan up or down the magnified picture.
SETUP MENU Navigating the setup menu 1. Press SETUP to display the setup main menu. 2. Press or to select a menu icon. 3. Press to access the submenu and , to select an option. 4. Press and then , to select one of the available options under submenu. 5. Press Enter to confirm your selection. 6. Press to return to a previous menu. 7. Press SETUP to exit from the setup menu. Language Setup Language Setup A B C A CB OSD Menu Audio Subtitle * OSD •To select the language of unit’s menus.
Screen Setup Screen Setup A B C CB TV AType Screen Saver TV System View Mode * TV Type 4:3 PS (Panscan) • When wide-screen video is played, this mode clips the right and left sides of the image so that it can be viewed on a conventional screen. • Some wide-screen DVDs that do not permit Pan Scan mode playback are automatically played in letterbox mode (black bands top and bottom).
Audio Setup * Digital out SPDIF/PCM Choose this setting, if your DVD player is connected to a 2-channel digital stereo amplifier. When playing a disc recorded with Dolby Digital and MPEG audio formats, audio signal will be modulated into a 2-channel PCM signal and it will be output from the Coaxial Output jack. SPDIF/RAW Choose this setting, if your DVD player is connected to a power amplifier with a coaxial cable.
*Parental ctrl Some DVD discs are equipped with a password function and are rated according to their content. The contents allowed by parental lock level and the way a DVD disc is controlled may vary from disc to disc. For example, if the disc allows, you could lock-out violent scenes unsuitable for children or you could lock out playback of the disc altogether. You cannot play DVD discs rated higher than the level you selected unless you cancel the parental lock function.
PLACEMENT Mounting in the Vehicle Use the supplied car mounting bags to install the main unit and monitor on the back of the vehicle's headrests. Tightly wrap the mounting strap around the headrest.
SAFETY WARNING! •On no account should this unit be used by the driver of a moving motor vehicle, or left unsecured in the vehicle whilst driving. •If this unit is being used by a passenger in your vehicle, be sure that it is secured or held safely, and does not obstruct any safety device (i.e. airbag, seat belt etc.) that is fitted. • All passengers should wear seat belts when using this unit in a moving vehicle. •If in doubt, please contact your vehicle manufacturer for further advice.
WARNING: • AC adaptor is used as the disconnect device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the AC adaptor of the apparatus shall be disconnected from the mains socket outlet completely. • Never use an AC adaptor that is damaged, route power lead in a safe manner and make sure it is not subjected to trapping or pinching. If the power lead is damaged refer to a qualified service agent.
* If there is a scratch, dirt or fingerprints on the disc, it may cause tracking error. Before playing, clean the disc with a cleaning cloth. Wipe the disc from the center out. Don’t store discs in places with high temperatures or high humidity, they can become warped. After playing, store the disc in its case. Important Note • Before transporting the unit, remove the disc from the disc compartment. TROUBLE SHOOTING No power. • Ensure the AC adaptor is connected. • Make sure that the unit is turned on.