Operating Manual PORTABLE LCD DVD PLAYER Model: MES-202 For information and support, www.lenco.eu READ THESE INSTRUCTIONS INCLUDED IN THIS IM THOROUGHLY PRIOR TO CONNECTING AND OPERATING. PLEASE RETAIN THIS MANUAL IN CASE YOU MAY NEED IT FOR FUTURE REFERENCE. THE ILLUSTRATIONS & GRAPHICS HEREIN ARE FOR REFERENCE ONLY AND SUBJECT TO CHANGE WITHOUT NOTICE.
TABLE OF CONTENTS OVERVIEW OF THE DVD PLAYER ............................................................................................................................................... 2 SLAVE SCREEN ............................................................................................................................................................................ 2 REMOTE CONTROL UNIT .................................................................................................................
OVERVIEW OF THE DVD PLAYER: 1. TFT SCREEN 2. LEFT&RIGHT SPEAKERS 3. PLAY/PAUSE BUTTON 4. STOP BUTTON 5. PREVIOUS&F.BWD BUTTON 6. NEXT&F.FWD BUTTON 7. SETUP BUTTON 8. SUBTITLE BUTTON 9. VOL- BUTTON 10. VOL+ BUTTON 11. REMOTE SENSOR 12. DC 9V IN & CAR PLUG 12V IN SOCKET 13. CHARGE INDICATOR 14. POWER ON/OFF SWITCH 15. POWER INDICATOR 16. AUDIO RIGHT SOCKET 17. AUDIO LEFT SOCKET 18. VIDEO SOCKET 19. PHONES JACK 20. DISPLAY ON/OFF SWITCH SLAVE SCREEN 1. TFT SCREEN 2. SPEAKERS 3. BRIGHTNESS BUTTONS 4.
BASIC CONNECTION y y y y y It is recommended to connect a multi-system TV. Ensure that this player and other equipment to be connected are set to the standby mode or off and disconnect the AC power cords before commencing connection. Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely. Read through the instructions before connecting other equipment. Ensure that you observe the color coding when connecting audio and video cables.
ON SCREEN DISPLAY INFORMATION When the player is in operation press the display button continuously on the remote control. The screen will display information about the: Title elapse, Title remain, Chapter elapse and Chapter remain in a sequence OPERATIONS PREPARATION Power on the TV set and select video input mode. Power on the audio system which is connected to the player. GET STARTED 1. Switch the POWER ON/OFF button to turn on the player. 2. Open the CD cover to place a disc onto the disc tray. 3.
MP3/MPEG 4 PLAYBACK 1. Load the MP3/MPEG 4 disc onto the disc tray and the TV screen will show all its folders after a few seconds. 2. Select the folder you want by the navigation buttons and then press the OK/ENTER button to confirm. 3. The files in this folder are displayed and select your favourable song via navigation buttons and press the OK/ENTER button to start playback. 4. Press the NEXT and the PREV button to select track directly. 5. Press the REPEAT button to change play mode.
3. VIDEO QUALITY SETUP 5.2.1 OLD PASSWORD 5.2.2 NEW PASSWORD 5.2.3 CONFIRM PASSWORD Procedure to change password: 1) Enter the old password in the OLD PASSWORD row 2) Enter the new password in the NEW PASSWORD row 3) Enter the new password again in the CONFIRM PASSWORD row You may reset the password if you forget the old password by using the supervisor password: 1389 3.1 SHARPNESS -to set the sharpness for the display. Options: HIGH MEDIUM LOW 3.2 BRIGHTNESS -to set the brightness for the display. 3.
TROUBLESHOOTING If your DVD player does not seem to be functioning properly, check the items below before you contact an authorized service center Symptom Power does not turn on or suddenly turns off. No picture or sound y y y y y y y y y y No picture No sound y y No picture and sound Distorted video or sound y y Check Make sure the AC adapter is securely plugged into an AC outlet. Turn the power off and then back on. Check that the A/V cables are securely connected.
