Gas Heater User Manual

SPECIFICATIONS: Model L20 DVF-2
PAGE 28
Flue Size 4” – Top Vent
Intake Pipe 6.625” (6 5/8”)
Height Overall 30 1/2”
Height 29”
Width 23”
Depth 15”
Fuel Natural Gas (standard)
(or) LP Gas (convertible).
Gas inlet 3/8” NPT-Male / Flex Line
(or) remove flex, 3/8” NPT–Female Flare.
Performance Variable Flame Control.
Features High Efficiency Heat Exchanger.
Natural Convection & Radiant Heat.
Standing Pilot / Operates During Power
Outages. Remote Control & Wall
Thermostat Capable.
Technical Honeywell Combination Gas Control
Features Valve, Millivolt - VS8520E. Safety Shut
Down Sensor (Reverse Flow Safety Switch).
Pan Burner with Tuned Ports.
Radiant & Fan (optional) assisted
convection heat.
Safety Test Tested and certified by CSA to ANSI standards.
Z21.88-1998 CSA 2.33a - M98. Vented Gas Fire-
place Heater
Heat Input 17,000 to 26,000 BTU’s (Nat. Gas)
17,000 to 24,000 BTU’s (Propane)
Ship Weight 185 lb.’s
Dimensions shown are approximations only (+ / - ¼”)
Top View
Side View
SPECIFICATIONS
GAS TYPE NATURAL GAS PROPANE (LP) MINIMUM CLEARANCES TO COMBUSTIBLES
Orifice Size #40 -.098 #53-.0595” Back Wall Min. 2 In. / 51 mm
Minimum Supply Pressure 4.5” WC 10.5” WC Side Wall Min. 12 In. / 305 mm
Maximum Supply Pressure 10.5” WC 13.0” WC Corner (45° angle)s
HIGH SETTING stove corner to wall, min. 2 In. / 51 mm
Manifold Pressure 3.5” WC 10.0” WC Ceiling Height Minimum 65 In. / 1651 mm
Input BTU / HR 26,000 24,000 Alcove Min. Height 65 In. / 1651 mm
LOW SETTING Alcove Min. width 47 In. / 1194 mm
Mainfold Pressure 1.8” WC 6.6” WC Alcove - Max. Depth into
Input BTU / HR 17,000 17,000 stove face to alcove opening 24 In. / 610 mm
Altitude - U.S.A. 0-4,500 Ft. (0-1372M) No derating
Altitude - Canada 0-4,500 Ft. (0-1372M) No derating
For installation higher than altitudes shown above, reorifice per Gas Codes
* With the orifice, manifold pressure and input ratings shown
above.
This Appliance is equipped at the factory for the use with Natural Gas or Propane (LP). Appliances using propane must be field conversed using
the LP Conversion Kit supplied with appliance.