Instruction Manual

Page 10
Pressure Switch Wiring KG/KC 180-300
Units Built Before 6/24/2013
1- KG/KC 180 & 210 Units - Disconnect unit wire to K10-A.
KG/KC 240 & 300 Units - Disconnect unit wire to K10-A
and K149-A.
2- Wire pressure switches. Refer to table 5 for
appropriate wiring diagram. See figure 12 to connect
harness wire to K10 or K10 and K149.
NOTE - Three different wiring harnesses are provided in
this kit. Use wiring harness which has stamps as shown in
appropriate figure; tape back unused wires. Discard
unused harnesses.
2- Bundle wiring and secure away from unit
components.
TABLE 5
Unit
Wiring Figure
KG/KC 180 Figure 13
KG/KC 210 Figure 14
KG/KC 240 & 300 Figure 15
KG/KC 156-300 UNIT K10 & K149/K150
RELAY CONNECTION
FIGURE 12
WIRE FROM HARNESS
LABELED “K10” OR
“K149/K150”
INSERT TERMINAL
INTO OPENING IN
RELAY
K10 OR
K149 RELAY
WIRING - KG/KC 180 UNITS
K10
AB
K10-A
S11
K10-A2
S11
K10
AB
S11
S84 S84
S84
Disconnect wire to K10 relay coil.
Connect to harness wire marked K10-A2
KIT WIRE HARNESS
K10-A
K10-A2
FIGURE 13