User's Manual

Users have to use the connection to USB interfaces with USB 2.0 version or higher.

Please make sure the temperature for device will not be higher than 40

The device could be used with a separation distance of 0cm to the human body.

The adapter shall be installed near the equipment and shall be easily accessible.

These devices complied with the essential requirements of Article 3 of the R&TTE

1999/5/EC Directive.

All the reports of the applied standards have the Positive Opinion of Notiﬁed Body:

PHOENIX TESTLAB, Königswinkel 10 D-32825 Blomberg, Germany

Electronic emission notices

CE Caution

Federal Communications Commission (FCC) Declaration of Conformity

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

This device has been tested and found to comply with the limits for a Class B digital ,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiated radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio communi-

cations. However, there is no guarantee that interference will not occur in a particular

installation If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user‘s authority to operate the equipment.