User Manual

3. Insert the new storage drive 1 and then pivot it downward 2 . Ensure that the new storage drive is
seated in place and the tape does not cover the speaker.
4. If necessary, connect the cable to the system board.
5. Reinstall the base cover assembly.
6. Reinstall the removable battery.
7. Turn the computer over. Connect the ac power adapter and all cables.
Replacing the M.2 solid-state drive
To remove the M.2 solid-state drive, do the following:
1. Disable the built-in battery. See “Disabling the built-in battery” on page 102.
2. Ensure that the computer is turned off and disconnected from ac power and all cables.
3. Close the computer display and turn the computer over.
4. Remove the removable battery. See “Replacing the removable battery” on page 102.
5. Remove the base cover assembly. See “Replacing the base cover assembly” on page 105.
Chapter 9. Replacing devices 113