User Guide

Replacing the base cover assembly
Before you start, read “Important safety information” on page v and print the following instructions.
To replace the base cover assembly, do the following:
1. Disable the built-in battery. See “Disabling the built-in battery” on page 92.
2. Ensure that the computer is turned off and disconnected from ac power and all cables.
3. Close the computer display and turn the computer over.
4. Loosen the screws and pry up the latches. Then remove the base cover assembly.
5. Install a new base cover assembly in place and tighten the screws.
Chapter 8. Replacing devices 93