User Guide

6. Insert a new M.2 solid-state drive by doing the following:
a. Align the contact edge of the new M.2 solid-state drive with the key in the slot. Then carefully insert
the drive into the slot at an angle of about 20 degrees
1 .
b. Pivot the M.2 solid-state drive downward
2 .
c. Install the screw to secure the M.2 solid-state drive
3 .
7. Reinstall the bottom cover.
8. Reinstall the removable battery.
9. Turn the computer over. Connect the ac power adapter and all cables to the computer.
Replacing the memory module under the bottom cover
Before you start, read “Important safety information” on page v and print the following instructions.
Attention: Do not touch the contact edge of the memory module. Otherwise the memory module might get
damaged.
To replace the memory module, do the following:
1. Turn off the computer and disconnect it from ac power and all cables.
2. Close the computer display and turn the computer over.
3. Remove the removable battery. See “Replacing the removable battery” on page 100.
4. Remove the bottom cover. See “Replacing the bottom cover” on page 103.
Chapter 10. Replacing devices 109