User's Manual
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Accessories
- Chapter 5. Secure your computer and information
- Chapter 6. Configure advanced settings
- Chapter 7. CRU replacement
- Chapter 8. Help and support
- Appendix A. Important safety information
- Appendix B. Accessibility and ergonomic information
- Appendix C. Supplemental information about the Linux operating system
- Appendix D. Compliance and TCO Certified information
- Appendix E. Notices and trademarks
6. Install a new M.2 solid-state drive:
a. Install the screw to secure the new M.2 solid-state drive on the bracket.
b. Turn over the new M.2 solid-state drive with the bracket. Insert the new M.2 solid-state drive to the
drive slot
1 . Then, pivot the bracket downward and install the screw to secure the bracket 2 .
7. Reinstall the base cover assembly.
8. Turn over the computer. Connect the ac power adapter and all disconnected cables to the computer.
Replacement procedure for the long M.2 solid-state drive
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 51.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See “Base cover assembly” on page 52.
5. Remove the screw that secures the M.2 solid-state drive
1 . Then, remove the drive from the drive slot
2 .
Chapter 7. CRU replacement 55