User's Manual
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Accessories
- Chapter 5. Secure your computer and information
- Chapter 6. Configure advanced settings
- Chapter 7. CRU replacement
- Chapter 8. Help and support
- Appendix A. Important safety information
- Appendix B. Accessibility and ergonomic information
- Appendix C. Supplemental information about the Linux operating system
- Appendix D. Compliance and TCO Certified information
- Appendix E. Notices and trademarks
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 51.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Take the tool out of the new keyboard packaging. Insert the tabs
a and b into the slot between the
TrackPoint buttons and the trackpad
1 . Slightly pivot the tool downward 2 to release the left and right
TrackPoint buttons. Then, remove the two TrackPoint buttons
3 .
Note: If your new keyboard is not shipped with the special tool shown in the following procedure, you
can use alternative tools to pry up the TrackPoint buttons.
4. Loosen the screws that secure the keyboard.
Chapter 7. CRU replacement 57