User Manual

4. Open the latches on both sides of the memory slot at the same time 1 , and then remove the memory
module
2 .
Note: A Mylar film might cover the memory module. To access the memory module, open the film first.
5. Install the memory module by doing the following:
a. Place the notched end of the new memory module toward the contact edge side of the memory slot.
Then, insert the new memory module into the memory slot at an angle of about 20 degrees
1 .
b. Pivot the memory module downward until it snaps into place
2 . Ensure that the memory module is
firmly installed in the memory slot and cannot be moved easily.
6. Reinstall the base cover assembly.
7. Connect the ac power adapter and all disconnected cables to the computer.
M.2 solid-state drive
Prerequisite
Before you start, read Appendix A “Important safety information” on page 85 and print the following
instructions.
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
Chapter 7. CRU replacement 57