User Manual

5. Remove the M.2 solid-state drive by doing the following:
Note: A Mylar film might cover the M.2 solid-state drive. To access the M.2 solid-state drive, open the
film first.
a. Remove the screw that secures the M.2 solid-state drive
1 . The M.2 solid-state drive is released
from the secured position and pivots upward.
b. Carefully remove the drive out of the slot
2 .
6. Install a new M.2 solid-state drive by doing the following:
Note: A Mylar film might cover the M.2 solid-state drive. To access the M.2 solid-state drive, open the
film first.
a. Align the contact edge of the new M.2 solid-state drive with the key in the slot. Then, carefully insert
the drive into the slot at an angle of about 20 degrees
1 and pivot the M.2 solid-state drive
downward
2 .
b. Install the screw to secure the M.2 solid-state drive
3 .
7. Reinstall the base cover assembly.
8. Connect the ac power adapter and all disconnected cables to the computer.
Chapter 7. CRU replacement 59