User Manual

Error messages
If you see a message that is not included in the following table, record the error message first, then shut
down the computer and call Lenovo for help. See “Lenovo Customer Support Center” on page 82.
Message
Solution
0190: Critical low-battery error
The computer turned off because the battery power is low. Connect the ac power
adapter to the computer and charge the batteries.
0191: System Security - Invalid
remote change requested
The system configuration change has failed. Confirm the operation and try again.
0199: System Security - Security
password retry count exceeded.
This message is displayed when you enter a wrong supervisor password more
than three times. Confirm the supervisor password and try again.
0271: Check Date and Time
settings.
The date or the time is not set in the computer. Enter the UEFI BIOS menu and set
the date and time.
1802: Unauthorized network card
is plugged in - Power off and
remove the network card.
The wireless network card is not supported on this computer. Replace with a
supported wireless network card.
210x/211x: Detection/Read error
on HDDx/SSDx
The storage drive is not working. Reinstall the storage drive. If the problem still
exists, replace the storage drive.
2202: Product Name is invalid.
Have the computer serviced.
2203: System configuration is
invalid.
Have the computer serviced.
2204: System configuration data
is invalid.
Have the computer serviced.
Error: The non-volatile system
UEFI variable storage is nearly
full.
Note:
This error indicates that the operating system or programs cannot create, modify,
or delete data in the non-volatile system UEFI variable storage due to insufficient
storage space after POST.
The non-volatile system UEFI variable storage is used by the UEFI BIOS and by
the operating system or programs. This error occurs when the operating system
or programs store large amounts of data in the variable storage. All data needed
for POST, such as UEFI BIOS setup settings, chipset, or platform configuration
data, are stored in a separate UEFI variable storage.
Press F1 after the error message is displayed to enter the UEFI BIOS menu. A
dialog asks for confirmation to clean up the storage. If you select “Yes”, all data
that were created by the operating system or programs will be deleted except
global variables defined by the Unified Extensible Firmware Interface
Specification. If you select “No”, all data will be kept, but the operating system or
programs will not be able to create, modify, or delete data in the storage.
If this error happens at a service center, Lenovo authorized service personnel will
clean up the non-volatile system UEFI variable storage using the preceding
solution.
78 T490, T590, P43s, and P53s User Guide